EN 13034: Protective clothing against liquid chemicals
The EN 13034 standard means that the clothing meets the requirements for clothing that provides limited protection against small splashes or a light mist of chemical liquids. Safety clothing with this certification is suitable for use in environments where there is a risk of exposure to small amounts of chemical splashes, but where full body protection is not required. Safety clothing with the EN 13034 certification is designed in such a way that the seams prevent liquids and chemicals from penetrating through the clothing.
About EN 13034 standard 
The EN 13034 standard specifies the requirements and test methods for type 6 chemical protective suits. Both single-use and reusable suits are covered by this standard. For associated equipment, such as gloves and boots, which are not an integral part of the suit, please refer to the corresponding product standards. Type 6 clothing is clothing that provides limited protection against small splashes or a light mist of chemical liquids. In general, this clothing will be made of liquid-repellent, but not completely liquid-tight materials.
Please note: wearing protective suits against liquid chemicals for a long time can result in heat stress!
Requirements for EN 13034 standardized work clothing
- When designing work clothing care must be taken to ensure that splashes cannot penetrate the clothing (e.g. through bag closures).
- The work clothing must pass the spray test
- A model must meet the conditions stated in the EN 340 standard
How is work clothing tested to comply with EN 13034 standards
In order to comply with the EN 13034 standard, various tests are carried out on the fabric work clothes is made. The cloth is tested for tensile strength, but also for chemical resistance. For this purpose 4 different solutions of chemicals are applied to the cloth. The amount of liquids that penetrate the cloth and the amount that slides off the cloth is then examined. The EN 13030 standard determines within which margins this should fall.
A spray test (mannequin test) is also carried out in which the finished product is tested for quality. During the test 7 movements are performed to determine how much liquid is allowed through the clothing. This test is not performed if it concerns partial protection of the body.
Instructions for cleaning the clothes
Always follow the instructions on the washing label. Do not use detergents that contain soap, but only synthetic detergents. After cleaning the clothing should be checked for abnormalities in the Teflon finish. The clothing may only be repaired with materials that meet the requirements and standards of the garment in question.
Popular Multinorm clothing